#!/bin/bash

set -eux

ARCH=${1:-}

if [ "$ARCH" = i386 ]; then
    # help apt to figure out replacing GI dependencies (we don't need them
    # anyway, but a lot of stuff is pre-installed in semaphore)
    sudo apt-get purge --auto-remove -y python3-gi gir1.2-glib-2.0

    # library -dev packages are not co-installable for multiple architectures,
    # so this can't go into the setup step
    DEVPKGS=$(grep -o '[^ ]*-dev' tools/semaphore-prepare | sed 's/$/:i386/')
    sudo apt-get install -y --no-install-recommends gcc-multilib pkg-config:i386 glib-networking:i386 glib-networking-dbg:i386 libc6-dbg:i386 libglib2.0-0-dbg:i386 $DEVPKGS
    export CFLAGS=-m32
    export LDFLAGS=-m32
elif [ -n "$ARCH" ]; then
    echo "Unknown architecture '$ARCH'" >&2
    exit 1
fi

gcc ./tools/careful-cat.c -o careful-cat
./autogen.sh --prefix=/usr --enable-strict --with-systemdunitdir=/tmp
make -j2 V=1 all

# only run distcheck on native arch
if [ -z "$ARCH" ]; then
    make -j8 distcheck check-memory 2>&1 | ./careful-cat
elif [ "$ARCH" = i386 ]; then
    linux32 make -j8 check check-memory 2>&1 | ./careful-cat
fi